How To Use

Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It can be reset by disconnecting power at the main electrical panel and waiting 5 minutes before plugging the unit back in.

The reflector screen is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the screen may collect dust particles; these can be removed by dusting lightly with a clean dry cloth. To remove fingerprints or other marks, clean the reflector screen damp cloth. Never use abrasive cleaners. Dry the screen completely with a lint free cloth to prevent water spots.

1. Remove the battery cover screw. Push down on the battery cover located on the back of the remote control. Slide the battery cover open. 
2. Install 3V (CR2032) Lithium battery in the battery holder. The positive (+) side of the battery faces up. 
3. Close the battery cover and put the screw back in place.

Certain electric fireplace remote controls run on AAA batteries hence follow 1 to 3 steps for AAA batteries.

• On your remote control, press the temp up / down button once to display the current set temperature.
• Press multiple times to increase / decrease the set temperature.
(Can also be adjusted on the Flame Connect App).

• On your remote control, press the light selection button to toggle through the various light setting for the top light, fuel beds and flame colour setting. 
• Ranging from ON to LGT4.
(Can also be adjusted on the Flame Connect App).

Press and hold the ‘heat’ and ‘temperature decrease’ buttons at the same time for 3 seconds to disable or enable the heat function. This action must be performed on the hidden touch controls.